Polyamide 6 MOS2 rods 

The addition of molybdenum sulfide (MoS2) to PA6 results in an increase of rigidity, hardness and dimensional stability due to its nucleating effect. Conversely, the material's impact strength is reduced as a result. The additive also lends the material improved sliding friction properties.

PA6+Mos2 rods are made of a cast nylon material which using the filler of MoS2 results in an improvement in the degree of crystallinity, bringing a higher degree of strength to the cast polyamide, still without any noticeable degradation of hardness. Increasing the crystallinity of this PA 6, the Mos2 filled Polyamide also results in better surface hardness and improved abrasion properties compared to standard cast PA 6.

• High rigidity
• High degree of hardness
• Good dimensional stability
• Lower impact strength
• Good fatigue strength
• Good mechanical damping properties
• Good sliding friction properties
• Good abrasion resistance

Application:

• Polyamide 6 MOS2 rods are used in Shipbuilding and ship repair: the bearings of propeller shafts and stern, steering and other devices, fan videos, ship machinery parts, and valves - the valves, pistons, poorly loaded gears, impeller pumps, housings and valve covers, axle boxes, plugs, caps, o-rings.
• Power and Electrical Engineering: pump bearings, screws and power ash, dust screws, ball mill, turbine shells, etc. for power plants, hydropower plants, hydropower, nuclear power plants.
• Food equipment: Polyamide 6 MOS2 rods are used in the food industry is very diverse. Details of Polyamide 6  MOS2 are applied in labeling machines, spill-packaging machines, separators, pumps, sealing machines, the equipment for processing of meat, for the production of machines