WEICON Ceramic W is a mineral-filled putty, extremely wear-resistant, high temperature resistant from -35°C up to +150°C, briefly up to +260°C.

White surface protection coating with extremely high resistance against abrasion and chemical substances. Thanks to its putty consistency, it can also be used on vertical surfaces and even overhead. This grade of plastic metal is designed for maximum wear protection and chemical/temperature resistance and is made from a precision mix of mineral-filled epoxy resin.

Plastic Metal WEICON Ceramic W is recommended especially for:

• For bonding and lining of aluminum oxide stones in mill production
• For the lining of highly stressed pump cases
• As wear protection for slide bearings, slides and pipes
• And everywhere where the use of dark products is not wanted for optical reasons.
• Sealing and protection of new equipment exposed to erosion and corrosion effects
• Protect pump casings, valves, impeller blades, containers for water
• Recovery of heat exchangers, tube sheets, and others. Water circulation circuits equipment
• Recommended for use as an upper (outer) coating of surfaces restored to provide a special smoothness

Plastic Metal Weicon Ceramic W can be applied in layers up to 10mm thick and cures with very little shrinkage (0.02%). Pot life for 200gm at 20ºC is about 120 minutes which allows for accurate application and minimum wastage.

This highly viscous putty has a 100:33 mix ratio and to make things simple, extra space has been left in the resin container so the entire contents of the hardener container can be added and thoroughly mixed.

Cured Plastic Metal Weicon Ceramic W withstands long-term exposure to temperatures between -35ºC and 200ºC as well as short-term spikes up to 260ºC. Plastic Metal Ceramic W has a mean compressive strength of 140 MPa (measured at 25ºC according to DIN 53281-83).